Cabletron Systems 42 Switch User Manual


 
Adding the STH to a Stack
Page 3-2
3.2.2 Adding the STH to a Stack
STH hubs are star-wired to the intelligent hub. To add STH hubs to a
stack, refer to Figure 3-1 and perform the following steps:
1. Attach an STH HubSTACK Interconnect cable to the "STACK" port on
the rear panel of an STH.
2. Attach the other end of the cable to one of the numbered STACK ports
on the back panel of the intelligent hub.
The port’s number determines the relative position of the STH hub in
the network’s ring sequence and is used by the intelligent hub’s
management system to identify the STH to the user.
3. Repeat steps 1 and 2 to attach up to four STH hubs in the stack.
Figure 3-1. Stacking the STH
To disconnect an STH hub from the stack, simply unplug its HubSTACK
Interconnect cable from the intelligent hub.
STACK
RESERVED
STH-24
TOKEN RING HUB with LANVIEW
®
SN
STACK
RESERVED
STH-24
TOKEN RING HUB with LANVIEW
®
SN
STACK
RESERVED
STH-24
TOKEN RING HUB with LANVIEW
®
SN
STACK
RESERVED
STH-24
TOKEN RING HUB with LANVIEW
®
SN
MicroMMAC-24T
TOKEN RING HUB
LANVIEW®
WITH
STACK 2STACK 1 STACK 4STACK 3