Cabletron Systems 42 Switch User Manual


 
Wall-Mounting the STH
Page 3-5
Figure 3-5. Installing the Wall Mounting Brackets
2. Select the wall location for the STH within 7 feet of a power outlet.
Warning: There is a SHOCK HAZARD whe drilling into walls
containing electrical wiring. Select a wall location where drill bits and
screw anchors will not come in contact with electrical wiring in the wall.
3. Get a pencil. With the wall mounting brackets attached to the STH,
position the STH against the wall where it will be permanently
mounted with the network port facing down, as shown in Figure 3-6,
and mark the screw holes’ positions on the wall.
4. Set the STH aside and carefully drill four 1/4" pilot holes, one for each
screw anchor.
5. Install the screw anchors.
6. Position the STH on the wall, aligning the screw holes over the
anchors and reinstall the four anchor screws to attach the STH to the
wall. Tighten the four anchor screws.