Cabletron Systems 42 Switch User Manual


 
Attaching the Strain Relief Bracket
Page 3-3
3.2.3 Attaching the Strain Relief Bracket
Attach the strain relief bracket to the front of the STH as follows:
1. Locate the strain relief bracket and four 8-32 x 3/8" screws from the
STH-ACCY-KIT package.
Warning: Use of longer screws may cause damage to the unit or
electrical shock.
2. Carefully turn the STH upside down.
3. Attach the strain relief bracket to the bottom of the STH as shown in
Figure 3-2.
Figure 3-2. Attaching the Strain Relief
3.2.4 Rack-Mounting the STH
Perform these steps to install the STH in a 19-inch rack:
1. Remove the four cover screws (two from each side) located along the
front edges of each side of the STH.
2. Using the four cover screws removed in step 1, attach the rack
mounting brackets to each side of the STH as shown in Figure 3-3.
3. With the mounting brackets installed, position the STH between the
vertical frame members of the 19-inch rack and fasten it securely with
the mounting screws as shown in Figure 3-4.
HubSTACK
STH-24
TOKEN RING HUB with LANVIEW
®
SUPPORTING 100 OHM UTP CABLE
16Mb/s
PWR
STACK
SPEED
4M 16M
24X 23X 22X 21X 20X 19X
18X 17X 16X 15X 14X 13X
12X 11X 10X 9X 8X 7X
6X 5X 4X 3X 2X 1X