Filter
Top Products
Overview
Introduction 1-7
Frame based 802.3x flow control is supported on all Ethernet ports operating in the full duplex
mode. Flow control can be enabled or disabled on a port-by-port basis.
Back pressure flow control is supported on all Ethernet ports operating in the standard mode of
operation. Flow control can be enabled or disabled on a port-by-port basis.
1.1.12 802.1 Port Priority
IEEE 802.1 port priority is incorporated in the IEEE 802.1D standard. It is used to assign a default
priority to the frames received without priority information in their tag header, to map prioritized
frames to the appropriate transmit queues, and to prioritize frames according to protocol type.
1.1.13 Management
Management of the SmartSwitch modules and 6C105 chassis is accomplished using the Local
Management application or remote SNMP management stations. Local Management is accessible
through the RS232 COM port on the front panel using a local VT100 terminal, or a remote VT100
terminal via a modem connection, and in-band via a Telnet connection. In-band remote
management is possible through any SNMP compliant Network Management Software.
Local Management, as described in your Local Management User’s Guide, provides the ability to
manage the SmartSwitches and offers information for Ethernet HSIMs or VHSIMs. Local
Management information for non-Ethernet HSIMs or VHSIMs is included in their respective
user’s guide. For details on how to get manuals, refer to the Related Manuals section in the About
This Guide section.
1.1.14 Switching Options
The SmartSwitch modules provide 802.1Q switching or SecureFast Switching Virtual Network
Services between all of the front panel interfaces including any optional HSIM and VHSIMs. In
the 802.1Q mode (the default mode of operation), the switch functions as an 802.1D switch until
802.1Q VLANs are configured.
SecureFast switching and IEEE 802.1Q switching allow migration to Virtual Network
technologies without requiring the replacement of existing equipment.