Cabletron Systems 924TXG Switch User Manual


 
2
Firmware Requirements
The DIGITAL MultiSwitch 900 Firmware Version 5.5 or higher is required to manage the following
versions of network modules:
We recommend you update your network module(s) to the latest revision. Refer to the following World
Wide Web site for the latest module revision upgrades and release notes:
http://www.cabletron.com/dnpg/dr/hubs/firmware/
Management Requirements
There are three processes that can be used to manage the DIGITAL MultiSwitch Fast Ethernet Switch
924TXG module:
Hardware Requirements
The minimum hardware revision level for the DIGITAL MultiSwitch Fast Ethernet Switch 924TXG
module that is required to support this release of firmware is hardware version 2.0.
clear
VISN Patch
To download the latest clearVISN patch software upgrades, go to either of the following World Wide Web
sites:
http://www.cabletron.com/dnpg/dr/clearvsn/patches/
http://www.cabletron.com/dnpg/dr/hubs/firmware/
Product Version Filename
DIGITAL MultiSwitch Fast Ethernet Switch
924TXG
1.1.1 MA111.bin
Using . . . You can . . .
The Console
Configure and manage the module. Procedures are described in Chapter 4
Configuring the Module found in the DIGITAL MultiSwitch Fast Ethernet
Switch 916TXG and 924TXG Installation and Configuration manual.
WebView
Configure and manage the module as described in the DIGITAL MultiSwitch
Fast Ethernet Switch 916TXG and 924TXG Web Management Guide.
The clearVISN Web
Suite
Manage the module using the clearVISN Web Suite. Procedures for managing
the module are described in the clearVISN Web Suite 3.0 Installation and
Getting Started Guide.