Filter
Top Products
COMP/ENCR Module Installation
CSX200 Installation Guide 4-5
COMP/ENCR Module Installation
To install the CSX200-COMP/ENCR into the CSX200 chassis, perform the following procedure:
• Attach one end of the antistatic wrist strap to your wrist and the other end to an approved
electrical ground.
• Unpack the CSX200-COMP/ENCR by carefully removing it from the shipping box and then
from the protective plastic bag. Do not cut the bag as the device could be damaged. If there are
any signs of damage, contact the Cabletron Systems Global Call Center. See the Getting Help
section of this document.
• Remove all power from the CSX200.
• You must remove the chassis cover of the CSX200 to install the CSX200-COMP/ENCR (refer
to Removing the CSX200 Cover on page 4-2).
• Locate the D-Type connector and the standoffs on the chassis (refer to Figure 4-3 on the
following page).
• The D-Type connector pins of the CSX200-COMP/ENCR only fit one way onto the CSX200
D-Type connector. Lower the CSX200-COMP/ENCR module onto the standoffs and align the
connector with the connector pins. Carefully insert the connector pins of the
CSX200-COMP/ENCR module into the CSX200 D-type connector.
• Press down firmly on the CSX200 COMP/ENCR module until the pins fit all the way into the
connector.
• Secure the CSX200-COMP/ENCR with the standoff screws supplied with the
CSX200-COMP/ENCR module.
• Replace the CSX200 chassis cover and reconnect power.
• The CSX200-COMP/ENCR installation is complete.
!
CAUTION
The CSX200-COMP/ENCR comes with a pre-attached metal cage. Do not remove
this cage.