Cabletron Systems DELHE-UA Network Card User Manual


 
Chapter 2: Installation
2-2 DELHE-UA User’s Guide
4. After removing the module from its antistatic bag, visually inspect the
device. If you notice any sign of damage, contact a DIGITAL
representative immediately. Save the antistatic bag in the event the
module must be reshipped.
2.2 INSTALLING FAST ETHERNET (PORT) INTERFACE
MODULES
Fast Ethernet (Port) Interface Modules (FEPIMs) must be installed in the
DELHE-UA before installing the DELHE-UA in the host device. The
FEPIMs provide connectivity to the network. At least one FEPIM must be
installed in either port one or port two. To install an FEPIM in the
DELHE-UA, proceed as follows:
1. Remove the coverplate from the port slot where the FEPIM will be
installed.
To remove the coverplate, refer to Figure 2-1 and proceed as follows:
a. Remove the two screws fastening the coverplate to the standoffs.
Save the screws.
b. Lift and remove the coverplate from the top of the front standoffs.
Only qualified personnel should perform installation
procedures.
The DELF3-UI uses Class 1 lasers. Do not use optical
instruments to view the laser output. The use of optical
instruments to view laser output increases eye hazard. When
viewing the output optical port, power must be removed from
the network adapter.
!
The FEPIM and the DELHE-UA are sensitive to static
discharges. Use an antistatic wrist strap and observe all static
precautions during this procedure. Failure to do so could
damage the FEPIM or the DELHE-UA.