Filter
Top Products
Chapter 2:
Installation
Page 2-2 EMC39-12 User’s Guide
2.2.1 Rack Mounting the EMC39-12
Before installing the EMC39-12, care must be taken to ensure that the
rack used will support the unit and that the rack remains stable with the
EMC39-12 installed. In order to allow for proper cooling within the rack,
there must be a two-inch clearance on either side of the unit. Refer to
Chapter 1,
Introduction
for power and environmental requirements.
The following procedures explain how to install the EMC39-12 in a
19-inch rack.
1. Remove four cover screws (two from each side) located along the
front edges of each side of the EMC39-12. Figure 2-1 shows the
location of the screws.
2. Using the four cover screws removed in step 1, attach the rack
mounting brackets to each end of the EMC39-12.
Figure 2-1 Installing the Rackmount Brackets
Do not remove the cover from the EMC39-12. There are no
user configurable devices inside and the electronics are
static sensitive.
Screws (4)
Rack Mounting
Brackets (2)
EMC39-12
Ethernet Media Converter
WITH
LANVIEW
TPLINK
XMT
RCV
FOLNK
12 11 10 9 8 7 6 5 4 3 2 1
PWR
12 10 9
87
6543
21
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
11
emc39bk Page 2 Monday, February 12, 1996 4:21 PM