Filter
Top Products
Configuration View Description
Redundancy View
Configuration Views Cabletron Ethernet Hubs
4-12 Management Module Guide
This button allows you to test the redundant circuit.
Test Time of Day
The time of day at which the redundant circuits should be tested. This field is
not available in the MRXI Redundancy View.
This button allows you to display the MMAC Redundancy Table. The
Redundancy Table allows you to set up redundant circuit connections between
any two or more hubs that have redundant capability in their firmware. For
more information on setting up redundant circuits, refer to Hub Redundancy
Management in this chapter.
You can double-click on any of the circuit names in the Redundancy Table to
access the MMAC Redundancy Information View. This view lets you set up
redundancy circuits. Table 4-3 provides the information contained in the view.
Test Redundant Circuits
Redundancy Table
Table 4-3. MMAC Redundancy Information View Fields
Field Definition
Circuit Name The name of the indicated circuit.
Retry Count The number of unanswered polls allowed for the
indicated circuit before the current connection is
declared bad.
Bd/Port Combination The number of board/port combinations associated
with the indicated circuit.
MAC Address Add
(IRM2, MRXI,
MiniMMAC)
Adds the Ethernet address to the polling list for the
indicated circuit.
IP Address Add (IRM3) Adds the IP address to the polling list for the indicated
circuit.
Number of Addresses The number of addresses associated with the indicated
circuit.
Circuit Enable Enables or disables the indicated circuit.
Circuit Number The number from the circuit names in the Redundancy
table (e.g., Circuit 04).
Board Port Instance The board number and port number that the
redundant circuit is connected to. For example, 3.6 is
board 3, port 6.
Port Circuit Status The current state of this port in the redundant circuit.
Port Circuit Type The type of port this port is in the redundant circuit.