Filter
Top Products
Chapter 2: Installation
2-8 HSIM-FE6 User’s Guide
9. Secure the HSIM-FE6 to the module faceplate using the mounting
screws saved in step 5.
10. Secure the HSIM-FE6 to the module standoffs using the standoff
screws included in the HSIM-FE6 shipping materials.
11. Reinstall the interface module in the chassis.
12. Reattach the network cabling to the interface module.
2.3.2 Installing the HSIM-FE6 in a Standalone Device
To install an HSIM-FE6 into a standalone device (e.g., 2H252-25R)
perform the following steps:
1. Power down the device and remove the power cord.
2. Note the ports that have cables attached to them. Write down the ports
and label the cables to make it easier to reattach the network properly
after the installation. Then disconnect the cables from the ports.
3. Attach the antistatic wrist strap (refer to the instructions outlined on
the antistatic wrist strap package).
4. Remove the standalone device chassis cover (refer to your specific
standalone device documentation for instructions on removing the
chassis cover).
5. Refer back to Figure 2-3 and remove the two faceplate mounting
screws and the HSIM coverplate. Save the screws.
6. Refer back to Figure 2-4 and place the HSIM-FE6 behind the
standalone device faceplate.
7. Align the HSIM connector of the HSIM-FE6 with the pins on the
standalone device.
To install the HSIM-FE6 in a standalone device, the device
must first be powered down. Ensure that you remove the power
cord and ONLY the screws required to remove the chassis
cover.
!
CAUTION
Ensure that the HSIM-FE6 connector aligns with the device
connector pins to prevent bending the pins. This can damage
both the HSIM-FE6 and the device.