Filter
Top Products
VHSIM-G02 User’s Guide 2-1
CHAPTER 2
INSTALLATION
To install the VHSIM-G02 you need the following items:
•
Phillips screwdriver
•
Antistatic wrist strap (shipped with the VHSIM-G02)
•
Standoff screws (shipped with the VHSIM-G02)
2.1 UNPACKING THE VHSIM-G02
Unpack the VHSIM-G02 as follows:
1.
Remove the VHSIM-G02 from the shipping box. Leave the module in
the antistatic bag until you are ready to install it.
2.
Attach the antistatic wrist strap. Refer to the instructions on the
antistatic wrist strap package.
3.
After removing the VHSIM-G02 from the antistatic bag, visually
inspect the device. If there is any sign of damage, contact Cabletron
Systems immediately. Refer to Section 1.5 for instructions. Save the
antistatic bag in the event the VHSIM-G02 must be reshipped.
Only qualified personnel should install or service this unit.
NOTE
Before using the VHSIM-G02 you should be familiar with the
IEEE 802.3z
,
IEEE 802.3ab
, and
IEEE 802.3x
specification.
The network installation must meet the guidelines contained in
the specification to ensure satisfactory performance.
!
CAUTION
The VHSIM-G02 and the host platform are sensitive to static
discharges. Use an antistatic wrist strap and observe all static
precautions during this procedure. Failure to do so could result
in damage to the VHSIM-G02 or host platform.
Do not use sharp metal objects to open the VHSIM-G02’s
antistatic bag. They can damage the VHSIM-G02.