Filter
Top Products
Section 5. Programming the Datalogger
5-15
;set serial mode to DTR, RTS always set, ignore CTS, 1 stop bit no parity,
;8 bit data length, 9600 baud and no handshake delay.
2: SDM-SIO4 (P113)
1: 1 Reps
2: 0 Address
3: 1 Send/Receive Port 1
4: 2049 Command
5: 3146 1st Parameters
6: 0 2nd Parameters
7: 0 Values per Rep
8: 0000 Loc [ _________ ]
9: 1.0 Mult
10: 0.0 Offset
;set up a simple filter 1999 search for floating point number.
3: SDM-SIO4 (P113)
1: 1 Reps
2: 0 Address
3: 1 Send/Receive Port 1
4: 2054 Command
5: 1999 1st Parameters
6: 0 2nd Parameters
7: 0 Values per Rep
8: 0000 Loc [ _________ ]
9: 1.0 Mult
10: 0.0 Offset
;the set up filter command requires a delay of 4ms, the nearest we can get
;is 10ms with P22.
4: Excitation with Delay (P22)
1: 1 Ex Channel
2: 0 Delay W/Ex (units = 0.01 sec)
3: 1 Delay After Ex (units = 0.01 sec)
4: 0 mV Excitation
;set flag one high so the above will only be done once.
5: Do (P86)
1: 11 Set Flag 1 High
;end of serial and filter setup.
6: End (P95)
;get two floating point numbers into locations 1 and 2.
7: SDM-SIO4 (P113)
1: 1 Reps
2: 0 Address
3: 1 Send/Receive Port 1
4: 4 Command
5: 0 1st Parameters
6: 0 2nd Parameters
7: 2 Values per Rep
8: 1 Loc [ Number ]
9: 1.0 Mult
10: 0.0 Offset