Filter
Top Products
Protocol Settings
3-4
3
Using a TCP/IP Network
1
On the TCP/IP Settings screen, press [IPv4 Settings] ➞ [IP
Address Settings].
2
In [IP Address Settings], specify the following.
● Using a fixed IP address:
❑
[DHCP], [RARP], and [BOOTP]: [Off]
Enter the appropriate values in [IP Address], [Subnet Mask], and [Gateway
Address].
NOTE
It takes about two minutes to check whether the DHCP, BOOTP, or RARP settings
can be used. If you do not plan to use one of these settings, it is recommended that
you turn them off.
● Obtaining automatically an IP address:
❑
[DHCP], [RARP], or [BOOTP]: [On]
If this information cannot be obtained via DHCP, RARP, or BOOTP after you
restart the machine, enter the IP address, subnet mask, and gateway address
to use the settings entered in this step.