Filter
Top Products
10
Part Names and Functions
A built-in micro processor which controls this unit may rarely malfunction
and need to be reset. This can be done by pressing the RESET button
with a pen, which will shut down and restart the unit. Do not use the
RESET function excessively.
*
AUDIO
R IN L
VIDEO IN
DVI-I/
RGB IN-1
SERVICE PORT
S-VIDEO IN
COMPUTER
AUDIO IN
AUDIO OUT
RGB IN-2/
COMPONENT IN/
RGB OUT
RESET
MCI
q DVI-I / RGB IN-1
Connect computer output (Digital/Analog DVI-I type) or Multi
Card Imager (optional) to this terminal. (p17)
Terminal
q w e r t y
u i o
i S-VIDEO IN
Connect the S-VIDEO output from video equipment to this jack.
(p18)
e AUDIO IN
Connect the audio output from video equipment connected to
r or i to this jack. (When the audio output is monaural,
connect it to L (MONO) jack.) (p18)
y COMPUTER AUDIO IN
Connect the audio output (stereo) from a computer or video
equipment connected to q or u to this jack. (p 17, 18)
r
VIDEO IN
Connect the composite video output from video equipment to
VIDEO IN jack. (p18)
u RGB IN-2 /COMPONENT IN / RGB OUT
This terminal is switchable and can be used as computer input ,
component input, RGB Scart 21-Pin Video input, or monitor
output. Set the terminal up as either Computer input or
Monitor output properly before using this terminal. An optional
cable is required when using this terminal as component input
or RGB Scart 21-Pin Video input. (p17,18)
(This terminal outputs analog signal from DVI-I IN / RGB IN-1
terminal only when using as Monitor out.)
o AUDIO OUT
Connect an external audio amplifier to this jack. (p17, 18)
This terminal outputs sound from AUDIO IN terminal (e or y).
t USB (Series B)
When operating the connected computer with the remote
control unit, connect USB port of your computer to this
connector with a USB cable. (p17)
w SERVICE PORT
This jack is used to service this projector.
*
Do not press this button. This button is used for optional
accessories.