Filter
Top Products
5
1. Introduction
Bottom
Adjustable Tilt Foot
(See page 23)
Adjustable Tilt Foot Lock Button
(See page 23)
Lamp Cover
(See page 50)
To turn the logo upside down, follow the steps below.
1. Push one end of the logo gently.
The other end will pop up slightly.
• The right drawing shows the part “C” is pressed gently.
• The part “n” on the other end will pop up.
2. Push and hold the end of the logo gently and rotate the logo by
holding the other end.
• The right drawing shows that with the part “C” pressed the logo is
rotated by holding the part “n” on the other end.
3. Release your hold and turn the logo upside down.
HINT: The Canon logo is on the panel of the projector cabinet . When projecting an image with the projector hung from the
ceiling, turn the Canon logo upside down.
NOTE: A spacer is attached to the rear foot at the factory.
To fine-adjust the height of the rear foot, remove the spacer and rotate the rear foot to the desired height. Do not throw away or
lose the spacer.