Filter
Top Products
21
VOL
-
VOL
+
MENU
BACK
3. Projecting an Image (Basic Operation)
Note on Startup screen (Menu Language Select screen)
When you first turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select one
of the 8 menu languages.
To select a menu language, follow these steps:
1. Use the SELECT
or
button to select one of the
8 languages for the menu.
POWER
BACK
INPUT
IMAGE
ASPECT
INFO.
MENU
NO
SHO
W
AUTO PC
2. Press the OK button to execute the selection.
After this has been done, you can proceed to the menu opera-
tion.
If you want, you can select the menu language later. See "Lan-
guage" on pages 37 and 43.
MENU
BACK
P
C
T
VOL
-
VOL
+
POWER
BACK
INPUT
IMAGE
ASPECT
INFO.
MENU
NO
SHO
W
AUTO PC
NOTE: Immediately after turning on the projector, screen flicker may occur. This is normal. Wait 3 to 5 minutes until the lamp
lighting is stabilized.
When the Lamp mode is set to Quiet, the LAMP indicator will light green.
If one of the following things happens, the projector will not turn on.
• If the internal temperature of the projector is too high, the projector will not turn on to protect the internal system.
Please wait for the projector's internal components to cool down.
• When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.
• If the lamp fails to light, and if the WARNING indicator flashes on and off in a cycle of six times, wait a full minute and
then turn on the power.