Filter
Top Products
20
The preparation display will disappear after 30
seconds.
(See page 54 for Lamp mode status.)
Connect the projector’s AC power cord into
an AC outlet. The POWER indicator lights
red. Open the lens cap.
Press the POWER button on the top
control or on the remote controller.
The POWER indicator lights green and
the cooling fans start to operate. The
preparation display appears on the screen
and the countdown starts.
Complete peripheral connections (with a
computer, VCR, etc.) before turning on the
projector.
The Filter warning and Lamp replacement icons may
appear on the screen depending on the usage state
of the projector.
4
After the countdown, the input source that
was selected the last time and the Lamp
mode status icon (p.54) appear on the
screen.
• When the Logo select function is set to , the
logo will not be shown on the screen (p.48).
• When or is selected in the
Display function, the preparation display will not
be shown on the screen (p.48).
• When the Auto input function is set to On 2, the
input signal will be searched automatically (p.47).
• When is selected in the Display function, the
VIDEO/PC selection window and the input signal
guidance window are not shown on the screen
(p.48).
5
If there is no signal input when start on the
projector, or the current signal is missed
while operating the projector, the VIDEO/
PC selection window will be displayed
on the screen, please move the pointer
to input source desired by pressing the
Point ▲▼ buttons and press the OK
button. And then follow the input signal
guidance window to correct the signal and
connection.
If the projector is locked with a PIN code,
PIN code input dialog box will appear. Enter
the PIN code as instructed on the next
page.
Lamp mode status
1
2
3
16