Filter
Top Products
52
This function is available when operating the
projector via network.
.. Supply the power to the network
function even after turning off the
projector by pressing the POWER
button on the remote controller.
You can turn on/off the projector
via network, modify network
environment, and receive an
e-mail about projector status while
the projector is powered off.
......... Select when you do not use
the projector via network. The
projector’s network function will
stop when turning off the projector.
Refer to the user’s manual of “Network Set-up
and Operation”.
When selecting , the cooling fans may
be running depending on the temperature inside
the projector even if the projector is turned off.
This function allows you to change the setting of
the P-timer and execute it.
Select one of the following options:
....... The P-timer display
appears on the screen and the
count up starts ()
.. The time set in the Timer setting
appears on the screen and the
countdown starts.
............. Use the Point ▲▼ buttons to set
the Timer (). is
available in Count down only.
Factory default value is 10 Min.
............... It executes the count up or count
down function. Press the OK
button at and the indication
changes into Stop. To stop
or , press
the OK button at on the
screen menu, then the indication
changes into Restart. Press the
OK button at Restart to resume
or .
Reset ............. Reset the P-timer values.
Press the OK button at Reset
to return to the following value;
........ "000:00"
... Timer that
you set
................ To exit the P-timer operation.
P-timer display
To stop the P-timer function, press the P-TIMER button.
To cancel the P-timer, press and hold the P-TIMER
button for a few seconds.
X: disabled O: enabled
*1 When is selected, it is only possible to turn on the
projector while using the RS-232C serial port.
*2 When switch the Standby MIC out function
On and in Standby mode status, only MIC
volume can be output.
Monitor Out
Audio Out
Direct power on
Serial command
Network
*1
*2