Filter
Top Products
52
• During is in progress, If the MENU
button or the POWER button is pressed,
will stop. If the COMPUTER 1/2 button oror
VIDEO or COMPONENT or S-VIDEO button is
pressed, will stop and go back to the
button's input signal.
• , and can
not be set at the same time.
• corrects vertical distortion only,
not correct horizontal distortion.
• The Auto Keystone function can not work when
the Ceiling feature is set On in the Screen menu
(pp. 38, 40, 48, 50).
• Perfect correction of the image distortion can not
be ensured with the Auto setup function. If the
distortion is not corrected properly by pressing the
AUTO SET button, adjust manually by pressing
the KEYSTONE button on the remote control unit
or selecting in the Setting menu (pp.
26, 38, 40, 48, 50).
• , , and
of some computers cannot
be fully adjusted with the Auto PC Adjustment
function. When the image is not provided properly
with this operation, manual adjustments are
required (pp. 33-34).
This function detects the input signal automatically.
When a signal is found, the search will stop. Use the
Point ▲▼ buttons to select one of the following options.
......... Auto input does not work.
On 1....... Auto input works under the following
situation.
– When pressing the AUTO SET button on
the top control or the remote control unit.
On 2....... Auto input works under the following
situation.
– When turning on the projector by pressing
the POWER button on the top control or
the remote control unit.
– When pressing the AUTO SET button on
the remote control unit or the top control.
– When the current input signal is cut off.*
* If the Blank or Freeze function is active, cancel it to
activate the Auto input. It is also unavailable when On-
Screen menu is displayed.
On.............Enables Auto PC Adjustment when
pressing the AUTO SET button on the
remote control unit or the top control.
.............Disables Auto PC Adjustment.
..........
Always works and corrects keystone
distortion according to the projector's tilt.
Manual......Works only when pressing the AUTO SET
button on the top control or the remote
control unit.
.............Disables Auto Keystone.
• While is set to On 1 or On 2, the
status of Input and Lamp are displayed every time
the signal is switched.
• Only the last selected input source can be
detected.
This function enables Auto input, Auto Keystone
correction and Auto PC adjustment by pressing the
AUTO SET button on the top control or the remote
control unit. Settings for those functions can be altered
as follows: