Filter
Top Products
Getting Started
18
1
Installing theInstalling the
CopierCopier
Checking the Package
Contents
Remove the copier and the
accessories from the shipping
box. Use the following checklist
to make sure you have received
all the necessary accessories
included with your copier.
Registration Card 1
Power Cord 1
Operator’s Manual 1
Cartridge 1
Muliti-stack tray 1
Copy tray 1
Item Quantity
Installation Procedure
Before installing the copier be
sure to check the safety of the
power source. Then proceed with
the following procedure.
Although the starter cartridge
comes already installed in the
main unit, it is necessary to
remove the sealing tape from the
cartridge before use.
The cartridge cannot be used if
the seal is not removed.
(See “Installation Precautions”,
on p. 11 and “Replacing and
Storing Cartridges”, on p. 19.)
Remove the copier from its shipping bag
and gently remove all the packing tape
attached to the copier.
Slightly slide the copy tray and the multi-
stack tray out from the opening between
the disc and the platen cover, and then
open the trays fully.
Slide the platen to the left, press the top
cover release button and lift open the top
cover. Grip the end of the cartridge, and
pull it out of the copier.
(See “Replacing and Storing Cartridges”,
on p. 19.)
Hold the cartridge level so that the side
with the written instructions is facing
upward.
Installing the Copier