Filter
Top Products
Using the Keypad/Display to Program, Monitor, and Control the Drive
3-1
CHAPTER 3
Using the Keypad/Display to Program,
Monitor, and Control the Drive
If you are unfamiliar with the detailed operation of the keypad/display, refer to chapter
3 of the LiquiFlo Software Start-Up and Reference Manual (D2-3410).
Figure 3.1 – Keypad/Display
!
ATTENTION:When switching from auto to manual, or manual to auto,
the drive will ramp to the reference level provided by the new source at
the rate specified in P.001 (Accel Time 1), P.002 (Decel Time 1), P.017
(Accel Time 2), or P.018 (Decel Time 2). Be aware that an abrupt speed
change may occur depending upon the new reference level and the rate
specified in these parameters. Failure to observe this precaution could
result in bodily injury.
P. - - -
Forward
Reverse
AUTO
MAN
ENTER
RUN
JOG
PROGRAM
START
STOP
RESET
SPEED
VOLTS
AMPS
Hz
Kw
TORQUE
Password
RUNNING
REMOTE
JOG
AUTO
FORWARD
REVERSE
PROGRAM
RELIANCE
ELECTRIC
Keypad
Display
Drive Status
LEDs
Monitor Mode
LEDs
Password LED
Stop / Reset Key
Start Key