Filter
Top Products
E-6
• Replace the batteries in accordance with the battery life marked on the side
of the battery.
Warning!
• Never use recharged batteries with the unit.
• Do not expose batteries to direct heat, do not short circuit them, and do not
try to take them apart.
•
Keep batteries out of the reach of small children. If swallowed, consult
with a physician immediately.
• Be sure to replace the batteries in accordance with the battery life printed on
the side of the battery itself.
To load the batteries
Caution
• Do not touch the springs inside the battery
compartment cover with your fingers while
loading or replacing batteries. The springs
have sharp areas and can cut your fingers.
1. Turn power off.
• If you are using the optional AC adaptor for power, you should also unplug it
from the Label Printer.
2. Turn over the label printer and remove the
cover as shown in the illustration.
3. Load batteries into the battery compartment.
• Be sure to use alkaline batteries.
• Make sure the positive (+) and negative (–)
ends of the batteries are facing correctly when
you load them.
4. Replace the back cover.
• As shown in the illustration, hook the cover
on the battery side of the compartment first,
and then close the cover.
• Make sure that the tape cartridge is securely
in place and that the back cover is closed
securely before using the label printer. A loose
tape cartridge can cause print quality prob-
lems.
AC Adaptor
Note the following important precautions when using an AC adaptor to power
your Label Printer.
• Use only a genuine CASIO AD-A95100 AC adaptor with the same voltage
rating as the household current in your area. Using a wrong adaptor can
damage your Label Printer.
• Be sure to turn the Label Printer off before you connect the adaptor. Do not
turn power on until the adaptor is connected to the Label Printer and plugged
into and AC outlet.
• Be sure to unplug the AC adaptor from the AC outlet whenever you are not
using the Label Printer.
AC Adaptor Cap
Remove the ADAPTOR CAP before connecting
the AC adaptor.
Insert the adaptor cap into the ADAPTOR CAP
holder located inside the back cover to avoid
losing the cap.
ADAPTOR CAP
Inside
back cover
ADAPTOR
CAP holder