Filter
Top Products
50
DSP Patch Parameter
The values of this parameter do not change when DSP Type and Tone Values are changed.
Note 1:
Selects the DSP Type. Receipt of GM/GS Reset selects 014 Delay. 200 is stored when a tone-associated DSP is read into
the DSP area.
Note 2:
See "42.6 Pan Setting Value Table".
DSP Type parameter
The value of this block's parameter is rewritten whenever the DSP type or tone is changed.
Note 1:
These parameters change the DSP name. One character is indicated by each byte.
Note 2:
This value is the DSP algorithm ID, which cannot be changed directly. Changing the DSP type or tone number causes the
algorithm ID of the original DSP to be copied automatically to this parameter. See "42.16 DSP Algorithm ID Table".
DSP Type Independent Parameters
The first eight parameters listed below are DSP User Parameters whose settings can be configured from this Model's control
panel. The next 16 parameters are Internal Parameters that cannot be changed on this Model's control panel. The range of
these parameter values is 0 to 127, regardless of the DSP algorithm. However, the number of parameter types depends on
the DSP algorithm, which means that not all User Parameters and Internal Parameters are necessarily available as a particular
DSP's parameters. See the "Part VII DSP Parameter List" for details about parameter types and contents.
ParamID Parameter bit Value Default Setting Value (Decimal)
2C DSP Type Number (Note 1) 08 00-C8 0E 0- 99 Preset
100-199 User
200 DSP of Tone
2D DSP Hold 01 0-1 0 0...Off
1...On
2E DSP Level 07 00-7F 64 0-127
2F DSP Pan (Note 2) 07 00-7F 40 -64 to 0 to +63
ParamID Parameter bit Value Default Setting Value (Decimal)
30 DSP Name A (Note 1) 20 0-FFFFFFFF 556e7469
MSB is leading character.
31 DSP Name B (Note 1) 20 0-FFFFFFFF 746c6564
MSB is leading character.
32r DSP Algorithm ID (Note 2) 07 00-3F 00 0-63
33 DSP Chorus Send 07 00-7F 40 0-127
34 DSP Reverb Send 07 00-7F 40 0-127