Casio XJ-A250V/XJ-A255V* Projector User Manual


 
Getting Ready
E-18
Before performing any of the operations in this section, make sure you first set up the projector and
connect to an output device.
AC Power Cord Precautions
Use the AC power cord that comes with the projector.
Make sure that you use a power source with the same voltage as that specified for the projector.
Do not share the outlet supplying power to the projector with other devices. If you are using an
extension cord, make sure that the ampere rating of the extension cord is compatible with the power
consumption value of this projector.
Never use the power cord while it is still bundled together.
Never place objects on top of the power cord and do not step on it.
Never pull on the power cord. When unplugging it, grasp the plug.
Use a conveniently located power outlet that you can reach easily when you need to unplug the
projector.
If you need more information about the power supply, contact your original dealer or authorized
CASIO service center.
To turn on the projector
1.
Use the bundled AC power cord to plug the
projector into a power outlet.
Plugging into a power outlet causes the three
indicators on the top of the projector to light
amber. After a short while, two of the indicators
will go out and only the POWER/STANDBY
indicator will remain lit amber, which indicates the
standby state.
Note that the projector will not turn on if you
press the [P] (Power) key while all three
indicators are lit amber. Wait until the projector is
in the standby state before trying to turn it on.
NOTE
This product is also designed for IT power distribution system with phase-to-phase voltage 230V.
2. Turn on the computer or video device that is connected to the projector.
3. If the projector lens cover is covering the lens, remove it.
4. Press the [P] (Power) key.
This causes the POWER/STANDBY indicator to flash green.
Within a few seconds, POWER/STANDBY indicator stops flashing and remains lit green, and the
projector starts projecting an image from the device connected to it.
A “Language” window will be projected the first time you turn on the projector. Use the procedure
under “Specifying the Display Message Language” on the page E-19 to configure the language
settings.
NOTE
If the Eco Mode is turned on, the LIGHT indicator will light green when the projector is turned on.
Turning On the Projector
Power supply connector
Bundled AC power cord
The shape of the plug
depends on your
geographical area.