Filter
Top Products
E-27
Troubleshooting
English
Important!Important!Important!
Try performing the following steps, which may or may not return the projector to normal
operation.
If normal operation does not resume after you perform the above steps, take the projector to
your retailer or authorized CASIO service center.
The remote controller
does not work.
The remote controller batteries may be dead.
➔ Replace the batteries (see “Replacing Remote
Controller Batteries”).
page E-13
The remote controller may be too far from the projector.
➔ Make sure the remote controller is within the
allowable range when you operate it.
User’s Guide
(UsersGuide_
English.pdf)
The TEMP or LIGHT
indicator is flashing or
lit.
➔ See “Error Indicators and Warning Messages”. User’s Guide
(UsersGuide_
English.pdf)
Light source unit does
not light.
The light source unit may be defective.
➔ Contact your original dealer or authorized CASIO service center for
replacement.
1. Unplug the AC power cord and wait for at least 10 minutes.
2. Plug the power cord back in and turn the projector back on again.
Problem Cause and Recommended Action See