Filter
Top Products
42
5
What you should do next depends on whether or not [ENTER] is displayed at
the far right of the setting you are configuring (the one that is highlighted).
If [ENTER] is displayed:
a. Press the [ENTER] key.
b. On the submenu that appears, use [T] and [S] to move the highlighting to the setting
you want to select.
Example: The following is the submenu that appears when “Display Sequence Setup” is
selected in step 2, above.
c. Press the [ENTER] key.
d. To return to the Viewer setup menu, press the [ESC] key.
If [ENTER] is not displayed:
Press the [W] or [X] key to select the setting you want (so its button is ).
6
Repeat steps 4 and 5 to configure other settings, if you want.
7
After all the settings are the way you want, press the [MENU] key to exit the
Viewer setup menu.
To restore all settings on the Viewer setup menu to their initial factory
defaults
1
Press the [MENU] key to display the setup menu.
2
Press the [T] key to move the highlighting to “USB” and then press the
[ENTER] key.
3
Press the [T] key once to move the highlighting to “Setup” and then press the
[ENTER] key.
z This will display the Viewer setup menu.
4
Press the [T] key to move the highlighting to “Initialize Viewer Setup” and then
press the [ENTER] key.
z This displays the dialog box shown below.