Filter
Top Products
TALKSWITCH VOIP NETWORK TROUBLESHOOTING GUIDE
4 WWW.TALKSWITCH.COM
rechecking this box updates the Server Names entries. The Registrar Authentication option
turns authentication on or off.
If this location is the proxy/registrar, make sure the box is checked and verify the server
name addresses and that both the proxy and the registrar entries are the same.
If FDQN is used, make sure the entries are typed correctly.
Verify that all locations have the proper proxy/registrar IP addresses.
Note: Leave the Outbound Proxy IP field blank, as it is not required for this type of
configuration.
2.2.2 Username and Password
All locations must have matching username and password entries used for authentication
purposes. If no Realm/Domain is entered, TalkSwitch will sub in ‘norealm’ for the
authentication packets.
If authentication is enabled by selecting yes(digest) in the Registrar Authentication
option, ensure the username and password are the same in all locations.
Note: Authentication is not required in a branch-to-branch VoIP configuration.
2.2.3 VoIP Lines
The VoIP Lines option is found in System Information -> VoIP Configuration.
Ensure the number of VoIP lines is set to a value other than zero.
2.3 VOIP NUMBERS
The Activate VoIP Number option is found in System Information -> VoIP Numbers.
Ensure all locations have at least one VoIP number activated and that no two locations
have the same VoIP number assignment.