Filter
Top Products
FuzzyScan Fixed Mount
Scan
Programming Manual
3
Install Your FuzzyScan
Adjust Reading Angle
The readability may be impacted by the specular reflection
caused by the perpendicular reading angle. To get the most
optimal reading performance, you are suggested to install
the FM400 at an approximate 15° angle to the
perpendicular line of the target barcode. However, the
reading angle and distance may vary depending on the size
and printing quality of barcodes.
Mount Your FuzzyScan
There are two M3 mounting holes on the bottom of the
chassis. Please follow below procedures to mount your
scanner.
Prepare two appropriate M3 screws (minimal 4mm in
depth) and decide your desired mounting location.
Then adjust the two screws to accommodate 27mm
center width.
Optimize the mounting position by adjusting the
reading angle and distance. Ensure the illumination
envelop is not blocked by any external object.
Use the test mode to verify the actual reading rate. If
the reading rate is not good enough, please adjust the
reading angle and distance to get the optimum
readability.
Front-view Side-view