Filter
Top Products
FuzzyScan
Programming Manual
Configure Your FuzzyScan
5
Scan
“
END
”
FuzzyScan will exit programming mode, and store all
parameters in Flash Memory ASIC or non-volatile memory,
then issue the completion beeping.
Scan
“
PROGRAM
”
FuzzyScan will enter programming mode,
and inhibit all non-programming functions.
Scan
“
SYSLIST
”
FuzzyScan will list the product information and
revision number to host via selected host interface,
then issue the completion beeping.
Scan
“
M_DEFAULT
”
FuzzyScan will recover all programmable
parameters into factory preset configurations,
then issue the completion beeping.
Program & End
Program & EndProgram & End
Program & End
Please note that the FuzzyScan will take 3-4 seconds to
store parameters in internal Flash Memory ASIC or
non-volatile memory after you scan the “END”. Please
don’t turn off the power before the completion beeping. It
may destroy all configured parameters.
System List, Group & Master Default
System List, Group & Master DefaultSystem List, Group & Master Default
System List, Group & Master Default