Filter
Top Products
FuzzyScan
Programming Manual
Configure Your FuzzyScan
50
PROGRAM
Condensed DataWizard
♦
♦♦
♦ Data Organizer Setting ♦
♦♦
♦
F_DEFAULT
Family Code Selection P.C
Parameter Selection Option Code
2nd Option Code
Organizer Control
SS
MS
MS
Disable
Select one bar code symbology
Select all bar code symbologies
FIN
(2 digits)
00
automatic termination
automatic termination
1st Organization
SS
DS
Disable
Enable
2-digits identified position;
Forward/backward data transmission setting
FIN
(2 digits)
position
direction
0 (Forward)
1 (Backward)
2nd Organization
SS
DS
Disable
Enable
2-digits identified position;
Forward/backward data transmission setting
FIN
(2 digits)
position
direction
0 (Forward)
1 (Backward)
Include/Exclude Control
SS
DS
Transmitted data excluded the data of identified position
Transmitted data included the data of identified position
0
1
The Data Organizer is used to edit the scanned raw data prior to transmitting the data to the host computers or terminals. It allows you to select desired bar code
symbologies for organizer control, and provides maximum two identified positions to send the data forward or backward. It also allows you to control the transmitted data
including or excluding the data of identification position. Please refer to the application example listed in page 45 for details.
While the Data Organizer is enabled, it arranges only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbology ID or Record
Suffix.
Regarding the “Bar Code Selection” and “Position Calculation” of Data Organizer, please refer to page 45 for details.
Please note that all “Character” input should be referred to the ASCII/HEX Table.