Filter
Top Products
12 Configuring TN3270 Server on the Channel Interface Processor
TN3270 Configuration Modes
DLUR SAP Configuration Mode
From DLURserver configurationmode, lsap commandputs you inDLUR SAP configurationmode.
Prompt:
tn3270-dlur-lsap>
PU Configuration Mode
There aretwo pathsto PU configurationmode: from theTN3270 server configurationmode, orfrom
the DLUR configurationmode. In eithermode, the pu commandputs you in PUconfiguration mode.
From TN3270 configuration mode, the pu command to create a new PU is:
pu pu-name idblk-idnum ip-address type adapno lsap [rmac rmac] [rsap rsap] [lu-seed
lu-name-stem]
From DLUR configuration mode, the pu command to create a new PU is:
pu pu-name idblk-idnum ip-address
From either mode, to return to PU configuration mode on PU pu-name the command is:
pu pu-name
Prompts:
tn3270-pu>
tn3270-dlur-pu>
Commands Allowed in Multiple Modes
The following commands are valid in TN3270 configuration mode, or in either variation of PU
configuration mode:
[no] tcp-port port-number
[no] idle-time seconds
[no] keepalive seconds
[no] unbind-action {keep | disconnect}
[no] generic-pool {permit | deny}
[no] shutdown
Values entered in PU configuration mode override settings made in TN3270 configuration mode. In
addition, the no form of these commands entered in PU configuration mode will restore the
command value entered in TN3270 command mode.