Filter
Top Products
Cisco IOS Release 11.0 BT Release Note and Update to Configuration Guides and Command References 3
Release Note
Platform Support
Cisco IOS Release 11.0 BT supports the following router platforms:
• Cisco 7500 series
• Cisco 7000 series and Cisco 7000 series with RSP7000
Cisco IOS Packaging
The following feature sets are available in Release 11.0 BT. Refer to the Router Products Release
Notes forCisco IOSRelease 11.0 fora listof thefeatures providedin theCisco 7000 andCisco 7500
series feature sets.
• Enterprise (this feature set includes CIP)
• Enterprise/CIP2
Boot ROM Requirements
Boot ROMs that support Cisco IOS Release 11.0 are required. No special requirements exist for
Cisco IOS Release 11.0 BT.
CIP Boot Image Requirements
The CIP boot image is bundled in the Cisco IOS Release 11.0 BT image. You must have the image
that supports your CIP or your CIP2 hardware. You cannot run a CIP and a CIP2 card in the same
router. See Table 1 for a list of image names and supported CIP or CIP2 cards.
Table 1 11.0 BT Image Names for CIP and CIP2 Hardware
Memory Requirements
The memory requirements for Cisco IOS 11.0 BT are shown in Table 2. The CIP supports up to
128 Mb of memory.
Table 2 11.0 BT Memory Requirements
Image Names Supported CIP Hardware
rsp-k-mz CIP
rsp-k2-mz CIP2
gs7-k-mz CIP
gs7-k2-mz CIP2
Cisco 7500 Series
and Cisco 7000
with RSP7000
MinimumRequired
Code Memory
Required Main
Memory
Required CIP
Memory
Release11.0
Runs From
Enterprise Set
(rsp-k-mz)
8 MB Flash memory
card
24 Mb 32 Mb RAM
Enterprise/CIP2 Set
(rsp-k2-mz)
8 MB Flash memory
card
24 Mb 32 Mb RAM