Filter
Top Products
9
Warning
The ports labeled 10/100-Mbps Ethernet port and Console port are safety extra-low voltage (SELV) circuits. SELV
circuits should only be connected to other SELV circuits. Because BRI circuits are treated like telephone-network
voltage, avoid connecting the SELV circuits to the telephone network voltage (TNV) circuits. (To see translated
versions of this warning, refer to the Regulatory Compliance and Safety Information for Cisco 1700 Routers
document that came with the router.)
Caution Always connect the Ethernet cable to the yellow ports on the router. Do not connect the cable to an ISDN S/T or
U port on a WIC or to an NT1 that is connected to a WIC. Accidentally connecting the cable to the wrong port can
damage your router.
Follow these steps to connect the router to your local network:
Step 1 Connect one end of the Ethernet cable to the yellow Ethernet port (labeled 10/100-Mbps Ethernet port), as shown in
Figure 8.
Figure 8 Connecting the Router to the Local Network
Step 2 Connect the other end of the Ethernet cable to a network port on the hub or switch.
7 Connect Power and Verify Installation
Read the following warnings before connecting the power to the router.
Warning
The power supply is designed to work with TN power systems.
1
10/100 Ethernet port
3
Straight-through Ethernet cable
2
Ethernet hub or switch
C
isco 1700
S
e
rie
s
10/100 ETHERNET
AU
X
CON
SOLE
ETHERNET
SPEED
1
5
2
6
3
7
4
8
LED
100BaseTX
SOLID
10BaseT
BLINK
1X
2X
3X
4X
5X
6X
7X
MDI MDI-X
8X
PVDM 0
OK
OK
PWR
1
0
SLOT 0
OK
PVDM 1
OK
MOD
OK
1
0
SLOT 1
OK
LINK
100
FDX
ACT
COL
10
SLOT 2
OK
1
0
SLOT 3
OK
3
2
1
60945