Filter
Top Products
Cisco Hoot and Holler over IP
session protocol multicast
30
Cisco IOS Release 12.1(5)T
session protocol multicast
To set the session protocol as multicast, use the session protocol multicast dial-peer configuration
command. To negate this command and return to the cisco default session protocol, use the no version
of this command.
session protocol multicast
no session protocol multicast
Syntax Description There are no keywords or arguments.
Defaults When this command is not implemented, the default session protocol is cisco.
Command Modes Dial-peer configuration
Command History
Usage Guidelines Use the session protocol multicast dial-peer configuration command for voice conferencing in a Hoot
and Holler networking implementation. This command allows more than two ports to join the same
session simultaneously. It is supported on Cisco 2600 and Cisco 3600 series routers.
Examples The following example shows the use of the the session protocol multicast dial-peer configuration
command in context with its accompanying commands:
Router(config)# dial-peer voice 111 voip
Router(config-dial-peer)# destination-pattern 111
Router(config-dial-peer)# session protocol multicast
Router(config-dial-peer)# session target ipv4:237.111.0.111:22222
Router(config-dial-peer)# ip precedence 5
Router(config-dial-peer)# codec g711ulaw
Related Commands
Release Modification
12.1(2)XH This command was introduced on Cisco 2600 and Cisco 3600 series routers
for the Cisco Hoot and Holler over IP application.
Command Description
session target ipv4 Assigns the session target for voice-multicasting dial peers.