Filter
Top Products
Cisco Hoot and Holler over IP
Glossary
31
Cisco IOS Release 12.1(5)T
Glossary
CIR—Committed information rate. The average rate of information transfer a subscriber (for example,
the network administrator) has stipulated for a Frame-Relay PVC.
Codec—Coder-decoder. Device that typically uses pulse-code modulation (PCM) to transform analog
signals into a digital bit stream and digital signals back into analog signals. In Voice over IP, it specifies
the voice-coder rate of speech for a dial peer.
Dial peer—An addressable call endpoint that contains configuration information including voice
protocol, a codec type, and a telephone number associated with the call. There are five kinds of dial
peers: POTS, VoIP, VoFR, VoATM, and VoHDLC. In Voice over IP, there are two kinds of dial peers:
• POTS—Connected through a traditional telephony network and points to a particular voice port on
a voice network device.
• VoIP—Connected through a packet network (IP network for VoIP) and points to specific VoIP
device.
DSP—Digital signal processor.
DTMF—Dual tone multifrequency. Uses two simultaneous voice-band tones for dial such as
touch-tone.
E&M—Ear and mouth. Stands for the 2-wire or 4-wire interface with separate signaling paths for the
receiving and transmitting signals—a type of signaling traditionally used in the telecommunications
industry. Indicates the use of a handset that corresponds to the ear (receiving) and mouth (transmitting)
component of a telephone. E&M is a trunking arrangement generally used for two-way switch-to-switch
or switch-to-network connecting. The Cisco analog E&M interface is an RJ-48 connector that allows
connections to PBX trunk lines (tie lines). E&M is also available on E1 and T1 digital interfaces.
FXO—Foreign Exchange Office. An FXO interface connects to the Public Switched Telephone
Network (PSTN) central office and is the interface offered on a standard telephone. The Cisco FXO
interface is an RJ-11 connector that allows an analog connection at the PSTN's central office or to a
station interface on a PBX.
FXS—Foreign Exchange Station. An FXS interface connects directly to a standard telephone and
supplies ring, voltage, and dial tone. Cisco's FXS interface is an RJ-11 connector that allows
connections to basic telephone service equipment, keysets, and PBXs.
Hoot and holler—A broadcast audio network used extensively by the brokerage industry for market
updates and trading. Similar networks are used in publishing, transportation, power plants, and
manufacturing.
IVR—Interactive voice response. When someone dials in, IVR responds with a prompt to get a personal
identification number (PIN), and so on.
PBX—Private branch exchange. Digital or analog telephone switchboard or switching facility located
on the subscriber premises and used to connect private and public telephone networks.
PVC—Permanent virtual circuit.
QoS—Quality of service. QoS refers to the measure of service quality provided to the user.
TDM—Time-division multiplexing.
Trunk—Service that allows quasi-transparent connections between two PBXs, a PBX and a local
extension, or some other combination of telephony interfaces to be permanently conferenced together
by the session application and signaling passed transparently through the IP network.
VA D —Voice activity detection.
VIC—Voice interface card.