Cisco Systems 274 Network Card User Manual


 
Chapter 5 Troubleshooting the System Hardware
Power-On Self Test (POST)
5-14
Cisco Wide Area Virtualization Engine 274 and 474 Hardware Installation Guide
OL-17739-01
201-Memory Error RAM failure.
213-Incompatible Memory Module in Memory
Socket(s) X, X, ...
A memory module in memory socket identified in
the error message is missing critical SPD
information or is incompatible with the chip set.
214-DIMM Configuration Warning Populated DIMM configuration is not optimized.
219-ECC Memory Module Detected ECC
Modules not supported on this Platform
Recently added memory module(s) support ECC
memory error correction.
301-Keyboard Error Keyboard failure.
303-Keyboard Controller Error I/O board keyboard controller.
304-Keyboard or System Unit Error Keyboard failure.
404-Parallel Port Address Conflict Detected Both external and internal ports are assigned to
parallel port X.
410-Audio Interrupt Conflict IRQ address conflicts with another device.
411-Network Interface Card Interrupt Conflict IRQ address conflicts with another device.
501-Display Adapter Failure Graphics display controller.
510-Flash Screen Image Corrupted Flash Screen image has errors.
511-CPU, CPUA, or CPUB Fan not Detected CPU fan is not connected or may have
malfunctioned.
512-Chassis, Rear Chassis, or Front Chassis Fan
not Detected
Chassis, rear chassis, or front chassis fan is not
connected or may have malfunctioned.
514-CPU or Chassis Fan not Detected CPU or chassis fan is not connected or may have
malfunctioned.
610-External Storage Device Failure External tape drive not connected.
611-Primary Floppy Port Address Assignment
Conflict
Configuration error.
660-Display cache is detected unreliable Integrated graphics controller display cache is not
working properly and will be disabled.
912-Computer Cover Has Been Removed Since
Last System Startup
Computer cover was removed since last system
startup.
Table 5-10 Diagnostic Front Panel LEDs and Beep Codes (continued)
Control Panel Message Description