Filter
Top Products
2-7
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Hardware Installation Guide
OL-13269-01
Chapter 2 Switch Installation
Configuring the Switch
Figure 2-3 shows the switch being inserted into the server chassis.
Figure 2-3 Inserting the Switch into the Server Chassis
Configuring the Switch
To run the system configuration dialog, you must first connect the switch to a PC to run a terminal
emulation program. You can connect the switch to the PC either through the switch console port or
through the CMC console port. Instructions for these procedures are included in this section.
If you connect to the switch through the CMC, the switch console port is disabled. After you have
completed the configuration procedure, you must use the disconnect command to close the active
console port and re-enable the switch console port. Enter logout to log out of the switch, then enter
Ctrl \ to disconnect the CMC from the switch.
1 Switch 3 Release latch
2 Server chassis
250201
!
!
!
!
!
!
!
!
!
!
2
1
3
WS-CBS3130X-S
STK
B
A
17X
18X
19X
20X
X2-1
21
22
X2-2
23
24
M
M
B
R
C
O
N
S
O
L
E
M
O
D
E
M
S
T
R
S
T
C
K
S
Y
S
T
!
!
!
!
!
!
!