Filter
Top Products
2-24
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Hardware Installation Guide
OL-13269-01
Chapter 2 Switch Installation
Installing Devices in the 10-Gigabit Ethernet Slots
Figure 2-13 Installing Converter Modules
Removing a Module
To remove an X2 transceiver module or a converter module, follow these steps:
Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.
Step 2 For X2 transceiver modules, disconnect the cables from the module. For fiber-optic modules, install the
optical bore dust plugs.
Step 3 For converter modules, disconnect the cables from the SFP module. Remove the SFP modules from the
converter module.
Caution Do not remove the converter module with SFP modules or cables installed. Always remove any cables
and modules before removing the converter module from the slot.
Step 4 Carefully pull on the X2 module sleeve, or pinch the tabs on the converter module to disengage it from
the slot. Grasp the edges of the module, and carefully slide it out of the slot.
Step 5 Reinstall the dust cover in the 10-Gigabit Ethernet slot.
Caution The dust covers should always remain in place unless a module is installed in the slot.
Step 6 Place the module in an antistatic bag or other protective environment.
250288
ST
K
B
A
17X
18X
19X
20X
X2-1
21
22
X2-2
23
24