Filter
Top Products
Contents
iv
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Hardware Installation Guide
OL-13269-01
Using the Device Manager to Configure the Switch 2-13
Configuring the Switch Stack Master 2-15
Managing the Switch 2-15
Using the CLI 2-15
Using the Device Manager 2-16
Other Management Options 2-16
Planning and Creating a Switch Stack (Only 3130G-S and 3130X-S Switches) 2-17
Stack Cabling Configurations 2-18
Connecting the StackWise Plus Cables 2-21
Installing Devices in the 10-Gigabit Ethernet Slots 2-21
Installing X2 Transceiver Modules and Cisco Converter Modules 2-22
Installing SFP Modules 2-25
Connecting to 10/100/1000 Ethernet Ports 2-27
Where to Go Next 2-27
CHAPTER
3 Troubleshooting 3-1
Diagnosing Problems 3-1
Verify the Switch POST Results 3-1
Look at the Switch LEDs 3-2
Confirm the Switch Connections 3-2
Verify the Switch Performance 3-4
Clearing the Switch IP Address and Configuration 3-4
Replacing a Failed Stack Member 3-5
Locating the Switch Serial Number 3-5
APPENDIX
A Technical Specifications A-1
APPENDIX
B Connector and Cable Specifications B-1
Connector Specifications B-1
10/100/1000 Ports B-1
10-Gigabit Ethernet Module Interfaces B-3
Cisco TwinGig Converter Module Ports B-3
Console Port B-4
Cable and Adapter Specifications B-4
10-Gigabit Ethernet X2 Transceiver Module Cable Specifications B-4
SFP Module Cable Specifications B-6
Two Twisted-Pair Cable Pinouts B-6
Four Twisted-Pair Cable Pinouts for 1000BASE-T Ports B-7