Filter
Top Products
3
Insert the PCI Client Adapter
Antenna
connector
LEDs
Card edge
connector
Standard 2 dBi
dipole antenna
47521
1
Turn off the PC and all its components.
2
Remove the computer cover.
Note On most Pentium PCs, PCI
expansion slots are white. Refer to your PC
documentation for slot identification.
3
Remove the screw from the top of the
CPU back panel above an empty PCI
expansion slot. This screw holds the
metal bracket on the back panel.
Caution Static electricity can
damage your client adapter. Before
removing the adapter from the
anti-static packaging, discharge
static by touching a metal part of a
grounded PC.
4
Tilt the adapter to allow the antenna
connector and LEDs to slip through the
opening in the CPU back panel.
5
Press the client adapter into the empty
slot until the connector is firmly seated.
Caution Do not force the adapter
into the expansion slot as this could
damage both the adapter and the
slot. If the adapter does not insert
easily, remove the adapter and
re-insert it.
6
Re-install the screw on the CPU back
panel and replace the computer cover.
7
Attach the 2-dBi antenna to the
adapter’s antenna connector until it is
finger-tight. Do not overtighten.
8
For optimal reception, position the
antenna so it is straight up.
9
Proceed to the driver installation
instructions for your operating system.