Filter
Top Products
5-11
Cisco MWR 1900 Mobile Wireless Edge Router Software Configuration Guide
78-13983-04
Chapter 5 Command Reference
ppp mux pid
ppp mux pid
To set the default receiving PPP protocol ID, use the ppp mux pid command in interface configuration
mode. To remove this configuration, use the no form of this command.
ppp mux pid integer
no ppp mux pid
Syntax Description
Defaults The default is 33 (0x21), which is the IP protocol.
Command Modes Interface configuration
Command History
Usage Guidelines To use this command, you must first enable PPP multiplexing/demultiplexing.
Examples The following example sets the default PPP protocol ID to 8.
ppp mux pid 8
Related Commands
integer The default value of the PPP protocol ID. Possible values are 0 through
65534.
Release Modification
12.2(8)MC2 This command was introduced.
Command Description
ppp mux Enables PPP multiplexing/demultiplexing
ppp mux delay Sets the maximum delay.
ppp mux frame Sets the maximum length of the PPP superframe.
ppp mux subframe count Sets the maximum number of subframes in a superframe.
ppp mux subframe length Sets the maximum length of the PPP subframe.
show ppp mux Displays PPP mux counters for the specified multilink interface.