Filter
Top Products
20 ATM Cable Interface Processor (ACIP) Installation and Configuration
Using show Commands to Verify Interface Status
Following is an example of the show controller cbus display. Note the display of the ACIP’s
microcode version (20.2), PLIM type (SONET), and available bandwidth (155 Mbps).
Router# show cont cbus
MEMD at 40000000, 2097152 bytes (unused 2912, recarves 1, lost 0)
RawQ 48000100, ReturnQ 48000108, EventQ 48000110
BufhdrQ 48000120 (2961 items), LovltrQ 48000138 (2 items, 1632 bytes)
IpcbufQ_classic 48000140 (8 items, 4096 bytes)
3570 buffer headers (48002000 - 4800FF10)
pool0: 12 buffers, 256 bytes, queue 48000128
pool1: 244 buffers, 1536 bytes, queue 48000130
pool2: 339 buffers, 4544 bytes, queue 48000148
pool3: 4 buffers, 4576 bytes, queue 48000150
(additional displayed text not shown)
slot5: ACIP, hw 1.3, sw 20.2, ccb 5800FF70, cmdq 480000A8, vps 8192
software loaded from system
ATM3/0, applique is SONET (155Mbps)
gfreeq 48000148, lfreeq 480001C8 (4544 bytes), throttled 0
rxlo 4, rxhi 339, rxcurr 0, maxrxcurr 2
txq 480001D0, txacc 480000BA (value 226), txlimit 226
If the display indicates that the ACIP’s microcode is an earlier version than 205.02, check the
contents of Flash memory to determine if the required images are available on your system. (The
show flash command displays a list of all files stored in Flash memory.)
Use the show diagbus slot command to determine if your ACIP is recognized by the system and to
verify its hardware and board revision. Following is an example:
Router# show diagbus 3
Slot 3:
Physical slot 3, ~physical slot 0x8, logical slot 3, CBus 0
Microcode Status 0xB
Master Enable, LED, WCS Loaded
Board is analyzed
EEPROM format version 1
ATM Cable Interface Processor, HW rev 1.3, board revision B0
Serial number: 03177260 Part number: 73-1188-03
Test history: 0x00 RMA number: 00-00-00
Flags: cisco 7000 board; 7500 compatible
EEPROM contents (hex):
0x20: 01 08 81 03 00 30 7B 2C 49 04 A4 03 00 00 00 00
0x30: 58 00 00 00 FF 00 00 00 00 00 00 00 00 00 00 00
Slot database information:
Flags: 0x4 Insertion time: 0x5DC (1d18h ago)
This completes the ACIP installation and installation checks. If you installed a new ACIP, you must
now configure the new interface, as described in the following section.