FINAL DRAFT —Cisco Confidential
3-37
Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide
OL-17502-01
Chapter 3 Configuring General Router Features
Configuring the Management Ethernet Interface
Examples
In the following example, the Management Ethernet interface on the RSP in slot RSP1 is configured with
an IP address:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface MgmtEth0/RSP1/CPU0/0
RP/0/RSP0/CPU0:router(config-if)# ipv4 address 10.1.1.1 255.255.255.0
RP/0/RSP0/CPU0:router(config-if)# no shutdown
RP/0/RSP0/CPU0:router(config-if)# commit
RP/0/RSP0/CPU0:router(config-if)# end
RP/0/RSP0/CPU0:router#
RP/0/RSP0/CPU0:router# show interfaces mgmtEth 0/RSP0/CPU0/0
MgmtEth0/RSP0/CPU0/0 is up, line protocol is up
Hardware is Management Ethernet, address is 0011.93ef.e8ea (bia 0011.93ef.e8e)
Description: Connected to Lab LAN
Internet address is 10.1.1.1/24
MTU 1514 bytes, BW 100000 Kbit
reliability 255/255, txload Unknown, rxload Unknown
Encapsulation ARPA, loopback not set,
ARP type ARPA, ARP timeout 04:00:00
Last clearing of "show interface" counters never
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
375087 packets input, 22715308 bytes, 87 total input drops
0 drops for unrecognized upper-level protocol
Received 297320 broadcast packets, 0 multicast packets
0 runts, 0 giants, 0 throttles, 0 parity
48 input errors, 43 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
89311 packets output, 6176363 bytes, 0 total output drops
Output 53 broadcast packets, 0 multicast packets
Step 8
end
Example:
Saves configuration changes.
• When you issue the end command, the system
prompts you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
–
Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
–
Entering no exits the configuration session and
returns the router to EXEC mode without
committing the configuration changes.
–
Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
Step 9
show interfaces MgmtEthrack/slot/CPU0/port
Example:
RP/0/RSP0/CPU0:router(config)# interface MgmtEth
0/RP0/CPU0/0
Displays statistics for the management interfaces
configured on the router.
Command or Action Purpose