Filter
Top Products
A-23
Cisco 12404 Internet Router Installation and Configuration Guide
OL-11636-01
Appendix A Technical Specifications
Product Architecture
Connect each AC PEM to a separate AC power source.
A power factor corrector (PFC) allows the PEM to accept AC power source
voltage from an AC power source nominally operating between 100 to 120 VAC,
15-Amp service in North America; and a range of 185 to 264 VAC, 10-Amp
service, in an international environment.
Figure A-6 AC PEM
A 14 ft. (4.3 m) AC power cord is supplied to connect the AC PEM to the power
source.
Note Install an uninterruptable power source (UPS) as a safeguard against power loss.
DC Power Entry Module
The DC PEM and DC PDU is a 2-part unit, which measures 6.60 inches
(16.76 cm) deep by 14.30 inches (36.32 cm) wide by 3.50 inches (8.89 cm) high
and weighs 14.0 lbs (6.35 kg). Refer to Figure A-7.
1 AC PEM handle 4 Power cord receptacle
2 On/Off switch 5 LEDs
3 Bail Latch 6 Captive screws
IN
P
U
T
O
K
O
U
T
PU
T
F
A
IL
INPUT
100-240V
12A
50/80HZ
O
U
T
P
U
T
O
K
66289
456
1
2 3