Filter
Top Products
3-33
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03
Chapter 3 Installing the Router
Connecting to a DC Power Source
Figure 3-19 DC PDU
To connect source DC power to the DC PDU, see Figure 3-19 and Figure 3-20 and
follow these steps:
Step 1 Attach an ESD-preventive strap to your wrist and connect the leash to the chassis
or to another grounded, bare metal surface.
Step 2 Locate the DC PDU on the back of the router. The PDU is positioned directly
below and behind the blower module.
1 Captive screws (four) 4 DC PDU
2 DC power connector block (A) 5 Guide pin
3 DC power connector block (B) 6 Blower module connector
57992
1
2
6
5
4
3
POWER B
POWER A
+
GND
+
GND