1-25
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03
Chapter 1 Product Overview
Route Processors
Performance Route Processor
This section provides information about the PRP. The PRP is supported in both
the Cisco
12406 Router and the Cisco 12006 Router. Figure 1-8 shows the front
panel view of the PRP. The PRP is shipped with 20 MB of Flash memory as the
default configuration.
Figure 1-8 Performance Route Processor (Front View)
The PRP is available as Product Number PRP-1=, which includes one PRP with
512
MB of SDRAM and one 64-MB ATA Flash disk. A redundant PRP (Product
Number PRP-1/R=) is also available.
The PRP contains the following components:
• PowerPC processor—Motorola PowerPC 7450 CPU, which runs at an
external bus clock speed of 133
MHz and an internal clock speed of
667
MHz.
• SDRAM—Up to 2 GB of Cisco-approved SDRAM on two DIMMs. 512 MB
of SDRAM is the default shipping configuration. SDRAM is field replaceable
only when using Cisco-approved DIMMs.
• SRAM—2 MB of SRAM for secondary CPU cache memory functions.
SRAM is not user configurable or field replaceable.
• NVRAM—2 MB of NVRAM. NVRAM is not user configurable or field
replaceable.
• Memory—Additional memory components include onboard Flash memory
and up to two Flash disks.
• Sensors—Air-temperature sensors for environmental monitoring.
EJECT
RX
TX
PRIMARY
SLOT-1
SLOT-0
LINK
EN
RX
TX
ETH 1ETH 0 AUX
CONSOLE
PERFORMANCE ROUTE PROCESSOR 1 (PRP-1)
LINK
PRIMARY
EN
RESET
75041