Filter
Top Products
3-18
User Guide for Cisco Secure Access Control Server
OL-9971-01
Chapter 3 Network Configuration
Configuring Remote Agents (ACS Solution Engine Only)
Step 3 Enter or change AAA server settings, as needed. For information about the configuration options
available for the AAA server, see AAA Server Configuration Options, page 3-15.
Step 4 To save your changes and apply them immediately, click Submit + Apply.
Tip To save your changes and apply them later, choose Submit. When you are ready to implement
the changes, choose System Configuration > Service Control. Then, choose Restart.
Note Restarting the service clears the Logged-in User report and temporarily interrupts all ACS
services. This action affects the Max Sessions counter and resets it to (0).
Deleting AAA Servers
To delete AAA servers:
Step 1 In the navigation bar, click Network Configuration.
The Network Configuration page opens.
Step 2 Do one of the following:
• If you are using NDGs, click the name of the NDG to which the AAA server is assigned. Then, click
the AAA server name in the AAA Servers table.
• If you have not enabled NDGs, click the AAA server name in the AAA Servers table.
The AAA Server Setup for X page appears.
Step 3 To delete the AAA server and have the deletion take effect immediately, click Delete + Apply.
Note Restarting the service clears the Logged-in User report and temporarily interrupts all ACS
services. As an alternative to restarting when you delete AAA servers, in the preceding step you
can click Delete. However, when you do this, the change does not take effect until you restart
the system, which you can do by choosing System Configuration > Service Control. Then,
choose Restart.
A confirmation dialog box appears.
Step 4 Click OK.
ACS performs a restart and the AAA server is deleted.
Configuring Remote Agents (ACS Solution Engine Only)
This section presents information about remote agents and procedures for configuring remote agents in
the ACS web interface.