Filter
Top Products
3-22
User Guide for Cisco Secure Access Control Server
OL-9971-01
Chapter 3 Network Configuration
Configuring Remote Agents (ACS Solution Engine Only)
To edit a remote agent configuration:
Step 1 In the navigation bar, click Network Configuration.
The Network Configuration section opens.
Step 2 Perform one of the following steps, based on your use of NDGs:
a. If you are using NDGs, click the name of the NDG to which the remote agent belongs. Then, in the
NDG Remote Agents table, click the name of the remote agent configuration you want to edit.
b. If you are not using NDGs, in the Remote Agents table, click the name of the remote agent that you
want to edit.
The Remote Agent Setup for the agent page appears.
Step 3 Enter or select new settings for one or more of the following options:
• Remote Agent IP Address
• Port
• Network Device Group (displayed if enabled in Advanced Options in the interface configuration)
Note If the ACS into which you are currently logged does not provide configuration data for the
remote agent, none of the options can be edited. You can access the web interface for the ACS
that does provide configuration data to the remote agent by clicking the ACS name listed as the
Configuration Provider.
Step 4 To save your changes and apply them immediately, click Submit + Apply.
Tip To save your changes and apply them later, click Submit. When you are ready to implement the
changes, click System Configuration > Service Control, and then click Restart.
Note Restarting the service clears the Logged-in User report and temporarily interrupts all ACS
services. The Max Sessions counter is reset to 0.
Deleting a Remote Agent Configuration
Note You cannot delete a remote agent that you have configured to use for remote logging or Windows
authentication.
To delete a remote agent configuration:
Step 1 In the navigation bar, click Network Configuration.
The Network Configuration section opens.