Filter
Top Products
11-4
Cisco ONS 15600 Procedure Guide, R5.0
February 2008
Chapter 11 Change Card Settings
NTP-E150 Change the Optical Line Rate
Step 9 Click OK. The row on the Pluggable Ports pane turns light blue until the actual SFP is installed and then
the row turns white.
Stop. You have completed this procedure.
NTP-E150 Change the Optical Line Rate
Step 1 Complete the “DLP-E26 Log into CTC” task on page 16-39 to log into an ONS 15600 on the network.
Step 2 Click the Alarms tab:
a. Verify that the alarm filter is not turned on. See the “DLP-E157 Disable Alarm Filtering” task on
page 17-50 as necessary.
b. Verify that no unexplained conditions appear on the network. If unexplained conditions appear,
resolve them before continuing. Refer to the Cisco ONS 15600 SONET Troubleshooting Guide.
c. Complete the “DLP-E76 Export CTC Data” task on page 16-98 to export alarm and condition
information.
Step 3 In node view, double-click the ASAP card where you want to edit the PPM port rate.
Step 4 Click the Provisioning > Pluggable Port Modules tabs.
Step 5 Click the port with the port rate you want to change in the Pluggable Ports pane. The highlight changes
to dark blue.
Step 6 Click Edit. The Edit Port Rate dialog box appears.
Step 7 In the Change To field, use the drop-down menu to select the new port rate and click OK.
Step 8 Click Yes on the Confirm Port Rate Change dialog box.
Stop. You have completed this procedure.
Purpose This procedure changes PPM port rates for the ASAP card. Perform this
procedure if you want to change the port rate on a multi-rate SFP that is
already provisioned.
Tools/Equipment None
Prerequisite Procedures NTP-E157 Provision a Multirate PPM, page 11-2
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher