Filter
Top Products
11-6
Cisco ONS 15600 Procedure Guide, R5.0
February 2008
Chapter 11 Change Card Settings
NTP-E66 Modify Line and Status Thresholds for Optical Ports
Note If you need to remove the SFP, see the “DLP-E216 Remove an SFP” procedure on page 18-15.
If you need to remove the 4PIO, see the “DLP-E217 Remove a 4PIO Module” procedure on
page 18-16.”
Stop. You have completed this procedure.
NTP-E66 Modify Line and Status Thresholds for Optical Ports
Step 1 Complete the “DLP-E26 Log into CTC” task on page 16-39 at the node where you want to change the
settings. If you are already logged in, continue with Step 2.
Step 2 Complete the “NTP-E69 Back Up the Database” procedure on page 14-4.
Step 3 On the shelf graphic, double-click the OC-N card that you want to provision. The card view appears.
Step 4 Click the Provisioning > Line tabs. (Click Provisioning > Optical > Line tabs for the ASAP card).
Step 5 As needed, provision the options in Table 11-2 for each OC-N port.
Purpose This procedure changes line settings (line type, coding, and length), line
status (in service or out of service), and performance monitoring thresholds
for OC-48, OC-192 cards, and OC-N ports on ASAP cards.
Tools/Equipment None
Prerequisite Procedures NTP-E157 Provision a Multirate PPM, page 11-2
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Provisioning or higher
Table 11-2 OC-N Card Line Settings
Heading Description Options
Port # Identifies the port number
• For an OC-48 card: 1 – 16
• For an OC-192 card: 1 – 4
• For an ASAP card: up to 16 ports,
denoted by 4PIO module followed by
port number. (Example: 1-3-1
denotes the third port on 4PIO
Module 1.)
Port Name Provides the ability to assign the
specified port a name
User-defined; name can be up to 32
alphanumeric/special characters (blank
by default)
SF BER Sets the signal fail bit error rate
• 1E-3
• 1E-4 (default)
• 1E-5